Needto change a string or a complete set of strings on your bass? This Fender University video provides step-by-step instructions on how to get your bass ba
Thislesson is all about how to stop muting strings when playing guitar chords. If you aren't geting a full, clean sound out of your chords and you find you
Ifyou are finding the same string breaks at the bridge constantly, loosen the string off and check the condition of the saddle. You should see a smooth surface, and if there is any roughness or grooves you will need to resurface the saddle. As you tune up, the string will stretch across the rough surface and can cause constant string snapping
Movethe saddle forward (towards the pickups) if the Floyd Rose intonation is flat. Pull the saddle back (away from the pickups) if your Floyd Rose intonation is sharp. Be sure to properly re-tighten the screw so that the saddle doesn't move when you re-tune the string. 3. Tune the string back up and check intonation.
Headlinedby an amazing collection of acoustic guitars, The Guitar Shop offers every must-have for any guitar player — fine guitars, best strings, and even hard-to-find parts and accessories. The Guitar Hospital offers a complete service package for all your guitar needs. From basic guitar maintenance, precise fretwork & PLEK Setup, up to the
Asyou go up in string gauge, the extra tension will pull the neck up (forward). It is worth mentioning that if you are going down a gauge, you will often find that the effects will be reversed, so in this instance, the neck will move back. From a playability perspective, typical symptoms of a raised neck include a raised action (greater
Now depress the string at the 12th fret and compare the two pitches. Remember, play with a soft-to-medium attack for the most precise reading. If both notes are perfectly in tune on all strings, then you lucked out and are done! The more likely case is that the two notes are slightly sharp or flat.
1 Fret each string at the 2nd fret and check the action at the 1st fret. Generally, you want the distance between the bottom of each string and the top of the 1st fret to be as little as possible without the string buzzing. If it's too close, the string will vibrate against the fret and you'll get a buzz. [12]
